cardiograph analog ecg output signal port

#CARDIOGRAPH ANALOG ECG OUTPUT SIGNAL PORT SOFTWARE#

Input signal unit parameter value in the Simulink-PSĬonverter block to N*cm, the unit manager performs theĬonversion and the Ideal Torque Source block generates torque Generated by the Ideal Torque Source block, and therefore theĭisplay block would show the value of 1000. The Ideal Torque Sensor block is equal to the torque The parameters of other blocks in this example are chosen so that the output value of Ideal Torque Source block would generate torque of 1000 The Simulink-PS Converter block unitless, the TheĬonstant source block provides the value for this input signal. In the diagram below, the Ideal Torque Source blockĮxpects a torque signal, in N*m, on its S port. If you specify different units, commensurate with the expected default units of theĭestination block input, then the unit manager attaches these units to the input Simulink signal value and performs the necessary unit conversion when providing the Parameter set to 1, then the block does not apply scaling to the input If you leave the Simulink-PSĬonverter block unitless, with the Input signal unit Units are meter-kilogram-second or MKS (SI). Physical signal unit is inferred from the destination block.

The units of the output physical signal, it only provides a scaling value. In other words, the Input signal unit parameter does not determine For more information, see Working with Simulink Units.

#CARDIOGRAPH ANALOG ECG OUTPUT SIGNAL PORT SOFTWARE#

If you also specify a physical unit as an attribute of the Simulink signal connected to the input port of the block, the software checks that

Cardiograph analog ecg output signal port